Where is D3 on OpenMV H7? Need VBUS on a shield.

OpenMV Products
1

Hey I’m trying to route the VBUS signal up to a custom made shield. I think the fastest way to do this is to short out D3 according to the schematic.

The problem is that both the schematic and board files for the H7 is not actually for the H7 Plus, so I can’t confidently find that diode.

Can you please point out the actual diode I need to short?

Thanks

2

There are no board files for the h7 plus. Just the schematic. The board was done in cadence allegro and is not open source. The power supply system is on the bottom of the board. The diode is the 3-pin SOT looking device.