Hello,
I have an RT camera that starts in DFU mode.
I have tried to install the latest firmware and apparently it does it correctly (the message says everything went ok), but the camera starts again in DFU mode.
What can I do?
Please contact me for a replacement (DM me). It has a bad flash chip. A few of these units escaped the factory during the first RT1062 production run. We’ve updated our protocol to make sure this doesn’t happen again.
Hello,
What do you need to do the replacement?
Regards
Just send me your contact details where to send it. You’ve bought products from us before, I think. Can I pull your details from an order?
Hello,
Sorry for not answering before, I’ve been out on a business trip.
Yes, we have bougth products from you before.
You can pull our details from an order.