Design Problem with Motor

OpenMV Products
1

Hello everyone,

I’m doing a custom PCB for a stepper motor and I´ll be using a drv8825. I have followed the typical application of the IC but the motor I have doesn´t match the design requirements. I´m new to electronics, and don´t understand much yet, saying this, what I´ll need to change to match the following motor?
https://www.oyostepper.com/goods-1262-E-Series-Nema-17-Stepper-Motor-Bipolar-09-Deg-30Ncm-4248ozin-15A-42x42x38mm-D-Cut-Shaft-4-Wires.html
Thank you in advance for your support.

2

That’s a standard stepper motor. It has two coils that are rotated 90 degrees so you can step it. So, it should match the requirements for the motor driver.