After stop mode can't connect OpenMV to IDE

[paolo]

I wanted to try this stop mode (the secondo code in the link) but after running it, I can’t connect the OpenMV Cam any more: No Cam found.

Sleep Mode - Wakeup with external interrupt

Hello together, thank you for the great work on OpenMV. I’m using openMV camera M7 in a battery powered setup outdoors. To record only when something is happening my aim is to always have the openmv system to low-power mode, except sensor signals a HIGH on e.g. pin P0. I read the documentation about low power states. I require to resume the openmv fast, ~0.3s . Therefore pyb.standby() is not helpful, as it triggers a full system reset on wakeup. pyb.stop() seems the way to go. Resume execut…

EDIT: Resolved uploading firmware again.