After i updated the firmware on my open MV M7 board and tried to run the person recognition program again. it give me the following message :
Previously it did work on this camera? What could be the problem?
Hi, the tensorflow library was disabled on OMV3/F7 because it didn’t fit the flash/ram at that point, with the latest update the library is much smaller now and I think I can re-enable it on OMV3/F7.
That would be great! OMV3/F7 is this the same is the M7?
Just need to download the openMV ide again then of how can i resolve it?
Attached is the latest M7 firmware. Use Tools → Run bootloader to flash it onto your camera.
firmware.zip (1.15 MB)