When I connect the newly acquired openmv board, it opens up a sdcard (like on a phone). I was expecting it to be a serial port.
Running Linux Mint 18, 64bit. (similar to ubuntu).
Should I add rules to udev and if so, suggestions?
Dmesg shows:
sd 16:0:0:0: [sdb] Attached SCSI removable disk
[61003.119068] FAT-fs (sdb1): Volume was not properly unmounted. Some data may be corrupt. Please run fsck.
[61189.000595] usb 3-1: USB disconnect, device number 126
[61189.000689] cdc_acm 3-1:1.0: failed to set dtr/rts
[61189.303810] usb 3-1: new full-speed USB device number 127 using xhci_hcd
[61189.437003] usb 3-1: New USB device found, idVendor=1209, idProduct=abd1
[61189.437007] usb 3-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[61189.437008] usb 3-1: Product: OpenMV Virtual Comm Port in FS Mode
[61189.437010] usb 3-1: Manufacturer: OpenMV
[61189.437011] usb 3-1: SerialNumber: 000000000011
[61189.437523] cdc_acm 3-1:1.0: ttyACM0: USB ACM device
[61189.657704] usb 3-1: USB disconnect, device number 127
[61189.657819] cdc_acm 3-1:1.0: failed to set dtr/rts
[61190.207822] usb 3-1: new full-speed USB device number 7 using xhci_hcd
[61190.337083] usb 3-1: New USB device found, idVendor=1209, idProduct=abd1
[61190.337086] usb 3-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[61190.337088] usb 3-1: Product: OpenMV Virtual Comm Port in FS Mode
[61190.337089] usb 3-1: Manufacturer: OpenMV
[61190.337090] usb 3-1: SerialNumber: 000000000011
[61190.337619] cdc_acm 3-1:1.0: ttyACM0: USB ACM device
[61190.337866] usb-storage 3-1:1.2: USB Mass Storage device detected
[61190.338019] scsi host17: usb-storage 3-1:1.2
[61191.336206] scsi 17:0:0:0: Direct-Access uPy microSD Flash 1.00 PQ: 0 ANSI: 2
[61191.336497] sd 17:0:0:0: Attached scsi generic sg2 type 0
[61191.336653] sd 17:0:0:0: [sdb] 97 512-byte logical blocks: (49.7 kB/48.5 KiB)
[61191.336780] sd 17:0:0:0: [sdb] Write Protect is off
[61191.336782] sd 17:0:0:0: [sdb] Mode Sense: 00 00 00 00
[61191.336948] sd 17:0:0:0: [sdb] Asking for cache data failed
[61191.336950] sd 17:0:0:0: [sdb] Assuming drive cache: write through
[61191.342311] sdb: sdb1
[61191.343314] sd 17:0:0:0: [sdb] Attached SCSI removable disk
[61191.478740] FAT-fs (sdb1): Volume was not properly unmounted. Some data may be corrupt. Please run fsck.
should I be worrying about the failed to set dtr/rts?