Ok, just in case you need a description, I’ll give it to you now.
My camera is supposed to send a signal to an arduino when it detected something. This arduino then blinks with an led, and sends a signal back, when it’s done. Very easy, nothing complicated and it always worked fine.
But then suddenly, when I tested it one more time to make sure it works before I change something, the following happened.
The camera detected the thing, sent a signal, the arduino blinked with the led and sent the signal back. Everything fine. But now, the camera would stop detecting and instead blink it’s own green light (like when it turns on). It would do that every 5 seconds, so detecting something would be impossible…
As soon as I connected it to the IDE, to figure out, what the problem could be, everything worked just fine. It did what it was supposed to do, as many times as I wanted.
But then disconnected from the IDE, it wouldn’t work anymore.
I have not changed any of my code or any of my wiring, so I don’t see why it wouldn’t work. It is weird, that it works, when connected to the IDE, but as soon as it runs on battery and with an arduino only, it doesn’t work…
Do you know, why? How could I fix that problem? Would a reset of the camera would be enough?
Thank you very much,
Finn