How to get camera out of the plastic case.

General discussion about topics related to OpenMV.
DROBNJAK
Posts: 6
Joined: Thu Jul 12, 2018 1:54 pm

How to get camera out of the plastic case.

Postby DROBNJAK » Fri Jul 13, 2018 9:16 am

I need to get camera out of the persipex casing to clean sensor. Sensor definitely has some smudges on its surface, because they can be seen on the video. As well, I need to solder the pin headers. One can clearly see gohstly bluish patches in the bottom left and bottom right corners.

but I can't find an outside latch on the sim that goes around the case. I should hate to brake the nice casing just for one off opening.

Any good advice?
Attachments
Distortion-Test_06.jpg
Distortion-Test_06.jpg (12.93 KiB) Viewed 214 times
User avatar
kwagyeman
Posts: 2406
Joined: Sun May 24, 2015 2:10 pm

Re: How to get camera out of the plastic case.

Postby kwagyeman » Sat Jul 14, 2018 3:09 pm

Hi, on the left side of the case there are two holes for a flat head screw driver. Stick the screw driver in those two holes and turn it. The case should pop off.
Nyamekye,

Return to “General Topics”

Who is online

Users browsing this forum: No registered users and 3 guests