Page 1 of 1

only one device connected to the AP(wifi shield)

Posted: Tue May 15, 2018 9:01 am
by kidswong999
When I was running the MJPEG Streaming AP program, I found that there was only one device connected to the AP. If I wanted the phone and the PC to connect to the AP at the same time, I would be unable to connect to the network.

How to solve it? :D

Re: only one device connected to the AP(wifi shield)

Posted: Tue May 15, 2018 11:15 am
by kwagyeman
You'd need to re-write the program to support multiple threads feeding the video stream along with multiple TCP ports. I don't actually know how to do this.

Note that this is hard to do on a desktop PC too.

Re: only one device connected to the AP(wifi shield)

Posted: Tue May 15, 2018 12:58 pm
by iabdalkader
The AP mode only supports 1 client at a time. It's a WINC limitation.

Re: only one device connected to the AP(wifi shield)

Posted: Wed May 16, 2018 1:59 am
by kidswong999
OK, Thanks. :geek: