I have several problems with getting started with my new OpenMV Cam M7 with Windows 7.
When i plug camera into usb it will blink green leds couple of times and then continuously blue led.
And OpenMV IDE version is 1.8.0
So far so good.
-
Only firmware up to 2.5.0 is “working”. The one i installed is “OPENMV3\firmware.bin”. Is this the correct one?
If I try to install firmware 2.6.1, camera wont start blinking when plugged in. And removable disk doesn’t appear on my file explorer. -
With using firmware 2.5.0 I can connect to the camera, but if I try to execute script - nothing happens. And eventually IDE will crash.
I set the Drive in IDE to H:\ which is where my camera is. If i disconnect and reconnect(from IDE) it won’t remember this drive. Maybe this has something to do with problems? -
I tried to save led_control.py example as main.py on camera. I suppose it should start running when camera is plugged into usb and blink different leds.
But it won’t do anything (other than blink blue led).
Thanks!
/Mikko