Hello.
I made a winc1500 shield myself. But I can’t download the firmware.
I use a ttl-USB and run .\download_all.bat UART
I followed the link http://community.atmel.com/forum/atwinc1500-firmware-upgrade
BUT the Error is: Invalid chip ID.
Could you help me?
Thanks.
ERROR MESSAGE
Downloading Image…
-
Programmer for WINC1500 SPI Flash< *
-
Owner: Atmel Corporation *
Firmware Path (2B0) ./m2m_aio_2b0.bin
Firmware Path (3A0) ./m2m_aio_3a0.bin
Initialize programmer.
Detecting COM ports…
Found built-in WINC1500 UART (COM6)
(ERR):Invalid chip ID = 0x5a555a5a
(ERR):Connect NMC1500 Dx Fail
(ERR)Failed To initialize programmer
Fail
#######################################################################
######## ### #### ##
## ## ## ## ##
## ## ## ## ##
###### ## ## ## ##
## ######### ## ##
## ## ## ## ##
## ## ## #### ########
#######################################################################