WINC1500 shield download firmware

Hello.
I made a winc1500 shield myself. But I can’t download the firmware.
I use a ttl-USB and run .\download_all.bat UART

I followed the link http://community.atmel.com/forum/atwinc1500-firmware-upgrade

BUT the Error is: Invalid chip ID.

Could you help me?

Thanks. :slight_smile:


ERROR MESSAGE

Downloading Image…


  • Programmer for WINC1500 SPI Flash< *

  •    Owner:  Atmel Corporation         *
    

Firmware Path (2B0) ./m2m_aio_2b0.bin
Firmware Path (3A0) ./m2m_aio_3a0.bin

Initialize programmer.
Detecting COM ports…
Found built-in WINC1500 UART (COM6)

(ERR):Invalid chip ID = 0x5a555a5a
(ERR):Connect NMC1500 Dx Fail
(ERR)Failed To initialize programmer
Fail
#######################################################################

######## ### #### ##

## ## ## ## ##

## ## ## ## ##

###### ## ## ## ##

## ######### ## ##

## ## ## ## ##

## ## ## #### ########

#######################################################################

We expose the debug pins to update the firmware on the board. However, other than that you are on your own… Atmels doc on this is pretty good.