I am trying to transfer files to the board using ampy File Operations | MicroPython Basics: Load Files & Run Code | Adafruit Learning System
From the file directory I am doing the following:
ampy --port COM5 put motor.py
and I get this error message:
b’OK\r\nraw REPL; CTRL-B to exit\r\n>’
Traceback (most recent call last):
raise PyboardError(‘could not enter raw repl’)
ampy.pyboard.PyboardError: could not enter raw repl
On researching the problem, some suggestions may be that the COM port might be busy … I am wondering if it is because I have a main.py file that is autoexecuting on power-up?
Any recommendations on how to transfer files? I am trying to install the adafruit micropython drivers for the PCA9685 - https://learn.adafruit.com/micropython-hardware-pca9685-pwm-and-servo-driver/software