Greetings again. To physically move the OpenMV board, a standard R/C “hobby” servo fits the need. Under the methods listed in the documentation, servo.angle includes an optional speed parameter. The doc says if omitted, then no delay occurs. What about if the servo.speed function is used in a setup routine to define a speed? Does servo.speed set a “default” speed or must the “time” parameter be used with servo.angle every time it is invoked? Is the servo.speed function only applicable for servo.pulse_width and servo.angle needs the “time” parameter in every case?
Does servo.calibration set limits that are observed by any subsequent servo.angle or servo.pulse_width function?
So many questions! Austin