Hmm, you don’t get any sounds with Windows or anything else?
The USB pins may not have been soldered right. On the cameras we make we check that they work at the factory…
Try this, on Windows, connect the BOOT0 and 3.3V pin. Then plug into the PC. There should be a device that appears under the device manager (this is a windows admin tool that displays a tree view of everything in the system). Under USB devices you should see an ST DFU device. If that’s not there then there’s a hardware issue with the camera.
The cable i was using is correct. Apparently the Pin on the Camera module has some loose contact. If i hold the pin tight it works, i am able to detect it on the IDE. But not long enough…
Tried with a few other cables, same result.
Hi, so I followed the same instruction from the thread. I found the ST DFU device when it is connected to PC and BOOT and 3.3V is connected. However, the camera sill produces issue where it is not detected. it blink green, then white, then continuously blink blue . Is there a general sure way I can just reset everything ?
Thank you for your hint regarding the USB cable, @kwagyeman, which in my case solved the issue. The H7 camera was listed in the devices list in Windows 10 after I took another USB cable.