Page 1 of 1

Pan and tilt module

Posted: Thu Jun 27, 2019 12:41 am
by Rcroeder
Question, new to openmv, i assume the since the pan tilt module is a separate module, which I own along with the openmv 7 from the recent kickstarter funding, that it would have its own 'example' section like motor, servo. If it dies, I cannot find it. I see examples on the servo, discussions on how to modify the code, but no out of the box examples.

Re: Pan and tilt module

Posted: Thu Jun 27, 2019 1:56 am
by kwagyeman
Hi, the Pan and Tilt shield just exposes the Servo P7-P9 which are the servo pins. So, the servo examples under board control are valid for it. It's just a regulator with servo headers. Nothing special.