Hi, you just need to upload the uvc.bin image (Not sure if it’s released with the IDE yet). Note this will make OpenMV camera act as a UVC compatible cam (just like a standard webcam) you won’t be able to execute any scripts. If you want to revert to the default firmware, upload firmware.bin when the bootloader is running (green blinky).
Thanks for support but I tried uploading uvc.bin using bootloader and I can see the /dev/video0 now on my raspi3 but also when running guvcview now it doesn’t complain that not camera is attached but it still doensn’t run too. The program now just stops running at some point while never getting to the point where you can see an image or play with the controls.
This is a fresh new Raspi3 using the default OS you load using Noobs.
I’m trying to load OPENMV4/uvc.bin using the ide (Ctrl+L) on a H7+ board but after loading, nothing happens and I have to use the bricked recovery procedure.
You have to use the right firmware for your board, and when it’s loaded the camera should show up as a new UVC/camera. Note not all software support it, guvcview is known to work with it.