Openmv does not work

General discussion about topics related to OpenMV.
s_inner
Posts: 2
Joined: Mon May 21, 2018 3:09 am

Openmv does not work

Postby s_inner » Mon May 21, 2018 3:27 am

My OpenMV keeps flashing colored lights after connecting to the computer.
And it cannot run programs in the IDE, cannot write programs in.
I try to format the file system or refresh the firmware, but it does not work.

There is an ERROR.LOG. It shows that "FATAL ERROR:Failed to init sensor, error:-2"
User avatar
kwagyeman
Posts: 2118
Joined: Sun May 24, 2015 2:10 pm

Re: Openmv does not work

Postby kwagyeman » Mon May 21, 2018 11:37 pm

Hi, that's a fatal error and it should not have made it out of the factory with that error. Can you verify it's getting enough power? I.e. no damage to the USB cable? If so, can you email us a receipt with info about where you bought the camera from?
Nyamekye,
s_inner
Posts: 2
Joined: Mon May 21, 2018 3:09 am

Re: Openmv does not work

Postby s_inner » Fri May 25, 2018 5:01 am

kwagyeman wrote:
Mon May 21, 2018 11:37 pm
Hi, that's a fatal error and it should not have made it out of the factory with that error. Can you verify it's getting enough power? I.e. no damage to the USB cable? If so, can you email us a receipt with info about where you bought the camera from?
I have been using it for a few months. It may have been damaged during my use.
Now I have bought a new one.

Return to “General Topics”

Who is online

Users browsing this forum: Bing [Bot] and 2 guests