Hi, I am a newbie to OpenMV and Wifi programming. I had been searching for video board that not only can transmit video but transmit a small amount of command code to the controller board so that I can make, say, a controlled car with video feedback.
I bought the OpenMV and wifi-fi module and wrote simple html in Chrome browser and successfully saw the video using the sample codes provided by your web site.
However, I am not so familiar to the instructions, how can I send codes, e.g. using UDP through the wifi network to the OpenMV board ( M7), and what codes can I use to monitor the reception of command codes? do you have sample example ?
General discussion about topics related to OpenMV.
2 posts • Page 1 of 1
Hi, we just kinda have sockets TCP/UDP, but nothing else right now. WiFi isn't our main focus. If you'd like better WiFi support I recommend just using an ESP8266/ESP32/Particle with the camera. There are a lot more folks on that side working on the connectivity pieces. You can then just send serial commands to the camera and have it do things.
Who is online
Users browsing this forum: No registered users and 2 guests