I recently bought 2x OpenMV3s through Digi-Key, and then bought 2x OpenMV3s again. One set was R1 and one set was R2, as indicated by the silkscreen/label on the back. Is there any significant difference between the two revisions that I should be aware of? Other than that the R1 came with soldered headers and the R2 did not.
General discussion about topics related to OpenMV.
2 posts • Page 1 of 1
Nope, they both are the same. The R2 just comes with a sticker on the back to block light from entering the camera IC from the back.
Who is online
Users browsing this forum: No registered users and 2 guests