Page 1 of 1

Do I need to clean camera IC on new OpenMV H7?

Posted: Tue May 14, 2019 1:46 am
by chrisb2
I am reading the hardware setup instructions http://docs.openmv.io/openmvcam/tutoria ... setup.html, but they do not seem consistent with the construction of the H7. It looks like I first have to un-screw the two screws holding the camera module to the openmv board, then on the underside of the camera module un-screw the two screws holding the lens unit to the camera board. Is that correct?

Or perhaps its not necessary to clean camera IC on a new OpenMV H7?

thanks,
Chris

Re: Do I need to clean camera IC on new OpenMV H7?

Posted: Tue May 14, 2019 5:13 am
by iabdalkader
That is correct, but only if it needs cleaning. Our new manf. process makes sure the sensors are dust free.

Re: Do I need to clean camera IC on new OpenMV H7?

Posted: Wed May 15, 2019 12:37 am
by kwagyeman
Sometimes the sensor has dust on it. Most of the time not anymore.